Dealer Locator | Contact Us | Subscribe | Careers | About Us | Literature

  

Home > Customer Application Pictures

Customer Application Photos

Beveling 2 inch plate steel with portable track torch. Two torch setup, increases operating speed with pre-heat functionSide view of MAX 3 performing 45 degree bevel cut with 1 inch landClose up picture of bevel cut being performed on 2 inch mild steel. 45 degree cut on 2 inch mild steelPicture showing optimal torch angle to perform bevel cutting. Torch on left will be used for preheating the plate.45 degree bevel cut with 1 inch land. Still showing mill scale from cutting process. This can be removed by wiping off with a welding glove, slag hammer or grinder. Once scale is removed there will be a very smooth cut edge.45 degree bevel cut with 1 inch land. Still showing mill scale from cutting process. This can be removed by wiping off with a welding glove, slag hammer or grinder. Once scale is removed there will be a very smooth cut edge. Same pieces shown from different angle.Pieces are then stacked and made ready for metal finishing process. Pieces are stacked and made ready for transportation to next process.Another picture of 2 inch material being bevel cut. Shown with multiple land heights'. Done with Koike IK-12 Max3. S-200 gas system used in this process.Close-up photo of multiple weld edge preparation cuts. Wash-out made from initial pierce. Can be easily cleaned with grinder.Beveled edge made with Koike track burner, Oxy/Fuel process used. Straight cut made with Plasma. You can notice the

 

 

 

 

 

 

Have any photos or videos of your KOIKE equipment in action? Please share them with us. Click here

 

 

 

 

 

© 2018 Copyright. Koike Aronson, Inc. All rights reserved.
SITEMAP